Please refer to the list of states below to determine which SDS applies to your state:

WEST
California, Washington, Oregon, Arizona, Idaho, Nevada, Utah, Montana, Wyoming, Colorado, New Mexico, Alaska & Hawaii

LionGUARD Modified Bitumen Adhesive is a COLD-APPLIED, SBS POLYMER MODIFIED ASPHALT ADHESIVE, that provides great adhesive and elongation properties. LionGUARD Modified Bitumen Adhesive is available in brush and trowel grades.

USES
LionGUARD Brush-Grade is used to adhere to SBS modified bitumen membranes, base and ply sheets. LionGUARD Modified Bitumen Adhesive can also be utilized to adhere to conventional BUR ply sheets or fully granulated cap sheets.

LionGUARD Trowel-Grade can be used to make repairs on existing modified applications and flashings on vertical surfaces, i.e. skylights, vents, and pipes.

SPECIFICATION
ASTM D-3019 Type III

SURFACE PREPARATION
All surfaces should be free from oil, grease, dirt and lose materials. All BUR surfaces should be patched and repaired with LionGUARD 19 ULTRA Rubberized Flashing Cement and LionGUARD Glass Membrane. Metal surfaces must have all rust and scales removed.

ADVANTAGES
UL approved.
Excellent cure.
Tough, flexible, adhesive and cohesive film.
Excellent water and weather resistance.
Excellent general adhesive.
Excellent lap cement.
Good U.V. resistance.
Complies with current VOC regulations.
Elastomeric, moves with the substrate.

APPLICATION
Apply LionGUARD Modified Bitumen Adhesive at a rate of approximately 1 gallon per 100 square feet on horizontal and vertical surfaces; irregular surfaces may require slightly more material. LionGUARD Modified Bitumen Adhesive may be applied by squeegee, roller, brush or trowel.

COVERAGE RATE
Apply LionGUARD Modified Bitumen Adhesive at the rate of 1 gallon per 100 sq. ft.. On porous or irregular surfaces, 2 gallons per 100 sq. ft. may be required.

PHYSICAL PROPERTIES
Weight per Gallon: 8.65
Shear Strength: 18 lbs. / sq. in.
Peel Strength: 10 lbs./lin. in.
Elongation: 200%
Recovery: 80%
Cure Time: 24 to 48 hours @ 77F
Application Temperatures: 40F to 100F

CARE OF TOOLS
Equipment may be thoroughly cleaned after use with mineral spirits, taking the necessary precaution when handling combustible materials.

CAUTION
Do not use near an open flame. Avoid breathing solvent fumes and prolonged contact with skin. An excessive application may create blistering. Application at temperatures below 40F may take longer to cure. Do not take internally. If swallowed, do not induce vomiting. Call a physician immediately. Keep out of reach of children. Keep the container covered when not in use. Do not thin. Dispose of in an environmentally safe manner. Cover air intakes during application and while drying.

PACKAGING
Available in 5 gallon pails.

AttachmentSize
PDF icon Data Sheet for West States 295.29 KB
PDF icon SDS for West States 464.57 KB

© 2024 NEMEON, Inc. All Rights Reserved.

Site Map     Privacy Policy     Website Terms of Use     ADA Statement